Skyrc Quattro B6AC Manuel d'utilisateur télécharger pdf (Page 7)

Never attempt to charge or discharge the following types of batteries:

A battery pack which consists of different types of cells

(including different manufacturers)

A battery that is already fully charged or just slightly discharged

Non-rechargeable batteries (pose an explosion hazard)

Batteries that require a different charge technique from NiCd, NiMh, LiPo or gel cell

(Pb, lead-acid battery)

A faulty or damaged battery

A battery fitted with an integral charge circuit or a protection circuit

Batteries installed in a device or which are electrically linked to other components

Batteries that are not expressly stated by the manufacturer to be suitable for the

currents the charger delivers during the charge process

WARNING AND SAFETY NOTES

The allowable DC input voltage is 11-18V DC.

The allowable AC input voltage is 100-240V AC.

These warnings and safety notes are particularly important. Please follow the instructions

for maximum safety; otherwise the charger and the battery can be damaged or at worst it

can cause a fire.

Never leave the charger unattended when it is connected to its power supply. If any

malfunction is found, TERMINATE THE PROCESS AT ONCE and refer to the

operation manual.

Keep the charger well away from dust, damp, rain, heat, direct sunshine and vibration.

Never drop it.

This charger and the battery should be put on a heat-resistant, non-flammable and

non-conductive surface. Never place them on a car seat, carpet or similar surface.

Keep all flammable volatile materials away from the operating area.

Make sure you know the specifications of the battery to be charged or discharged to

ensure it meets the requirements of this charger. If the program is set up incorrectly,

the battery and charger may be damaged. Fire or explosion can occur due to

overcharging. This warranty is not valid for any damage or subsequent damage arising

as a result of a misuse or failure to observe the procedures outlined in this manual.

To avoid short circuiting between the charge lead, always connect the charge cable to

the charger first, then connect the battery. Reverse the sequence when disconnecting.

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Pas de commentaire

Skyrc Quattro B6AC Manuel d'utilisateur Page 7