Skyrc Quattro B6AC Manuel d'utilisateur télécharger pdf (Page 9)

WARNING AND SAFETY NOTES

Charging

During charge process, a specific quantity of electrical energy is fed into the battery. The

charge quantity is calculated by multiplying charge current by charge time. The maximum

permissible charge current varies depending on the battery type or its performance, and

can be found in the information by the battery manufacturer. Only batteries that are

expressly stated to be capable of quick-charge are allowed to be charged at rates higher

than the standard charge current.

Connect the battery to the terminal of the charger: red is positive and black is negative.

Due to the difference between resistance of cable and connector, the charger can not

detect resistance of the battery pack, the essential requirement for the charger to work

properly is that the charge lead should be of adequate conductor cross-section, and high

quality connectors which are normally gold-plated should be fitted to both ends.

Always refer to the manual by the battery manufacturer pertaining to charging methods.

Operate according to their recommended charging current and charging time. Lithium

batteries, in particular, should be charged strictly according to the manufacturer’s

instruction.

Close attention should be paid to the connection of Lithium batteries.

Do not attempt to disassemble the battery pack arbitrarily.

Please get highlighted that Lithium battery packs can be wired in parallel and in series. In

the parallel connection, the battery's capacity is calculated by multiplying single the

battery's capacity by the number of cells, bearing in mind that total voltage stays the same.

If the voltage is imbalanced, it may cause a fire or explosion. Lithium batteries are

recommended to charge in series.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Pas de commentaire

Skyrc Quattro B6AC Manuel d'utilisateur Page 9